Inverted Stairway In Canada: A Commander III with a rear-mounted auger finishes an inverted stairway test pour in Toulnoustouc, Quebec, Canada. The concrete sections will form the sides of a dam.
Tunnel Walkway In Germany: The top width of the walkway in the Finne Tunnel varied between 1.05 meters (3.4 ft) up to 1.75 meters (5.7 ft). Height of the walkway was variable also, from 600 millimeters (23.6 in) up to 950 millimeters (37.4 in).
Read more about this project in GOMACO World 39.2.
Sand Erosion Wall In Canada: Two conveyor belts mounted to the Commander III were needed to supply enough concrete to the mold for the unique profile around the lake’s edge at the Mahogany Central Beach site in Calgary, Alberta, Canada. The profile is a 2.5 meter (8.2 ft) wide sidewalk with an 800 millimeter (31.5 in) face.
Read more about this project in GOMACO World 43.1.
Slot Drain In Iowa: A contractor slipformed a flush flume floor with their GOMACO three-track Commander III for a cattle confinement in Akron, Iowa. The flume featured a nine inch (229 mm) diameter slot drain set inside a six foot (1.8 m) wide floor profile.
Read more about this project in GOMACO World 40.1.
Canadian Crane Runway Project: A three-track Commander III slipforms this container crane runway in Vancouver, British Columbia, Canada. It ranges from six to eight feet (1.82 to 2.5 m) wide, and 24 inches (610 mm) thick.
Read more about this project in GOMACO World 38.1.
Pipe Insertion Into Feed Bunks In Australia: The feed bunk mold has a hydraulic pipe inserter mechanism that allows the insertion of 4 ft. 3 in. (1.3 m) long pipes into the sidewall of the new feed bunk on-the-go while slipforming.
Read more about this project in GOMACO World 35.2.
Water Canal In Bulgaria: A three-track Commander III is slipforming water canal in the countryside near Lovetch, Bulgaria.